Details

---

E10 Lamp Holder with Dual Binding Posts | Educational Physics Circuit Base 💡🏫

This E10 Lamp Holder is a fundamental laboratory component designed for science education and basic electrical circuit experiments. Featuring an integrated base with dual binding posts, it provides an easy and secure way to incorporate small light bulbs into series or parallel circuits for classroom demonstrations.

Key Product Features

• Universal E10 Screw Base: Specifically designed to hold standard E10 miniature light bulbs, commonly used in physics kits and flashlight bulb experiments.

• Dual Binding Post Terminals: Equipped with two color-coded (red and black) screw-type terminals that allow for rapid connection of alligator clips or bare copper wires.

• High-Visibility Insulated Base: Mounted on a bright, non-conductive polymer base that is easily visible during group demonstrations and provides a stable platform for desktop work.

• Secure Electrical Contacts: Features high-conductivity internal brass threads and center contacts to ensure consistent illumination without flickering.

• Pre-Drilled Mounting Holes: The base includes integrated holes for users who wish to permanently screw the lamp holder onto a custom experiment board or wooden project base.

Technical Specifications

• Socket Type: E10 Miniature Screw Base.

• Terminal Type: 2 x Binding Posts (Plastic-headed thumb screws).

• Base Material: High-impact insulated ABS plastic.

• Base Color: High-visibility Green.

• Application: Ideal for STEM education, primary school science labs, and DIY electronics prototyping.

Top 3 Customer Questions & Concerns 🙋‍♂️

⚙️ What kind of bulbs fit in this holder? This holder is designed for E10 screw-base bulbs. These are typically small "pea" bulbs or flashlight bulbs with a 10mm diameter screw thread.

🔌 Can I use this with a standard wall outlet? No. This is an educational tool designed for low-voltage DC power (such as AA batteries or laboratory power supplies). Using this with high-voltage mains electricity is extremely dangerous and will result in equipment failure.

⚠️ How do I connect my wires to it? Simply unscrew the plastic red or black caps on the binding posts, insert your wire or the tip of an alligator clip into the opening, and tighten the cap back down to secure the connection.